Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterTrusted Chimney Liner & Rebuild for Newark Homeowners
Chimney liner and rebuild work in Newark typically runs $1,800 to $7,200 depending on whether you need a stainless liner dropped in or a full masonry rebuild from the roofline up. A mid-range job, replacing a damaged clay tile liner with a DuraFlex stainless system in a two-story brick home, usually lands between $2,400 and $3,900. We’ve inspected and serviced more than 38,000 chimneys since 2009, and in our Newark work we see the same three problems repeat: spalling brick from freeze-thaw cycles, cracked clay flue tiles from old furnace exhaust, and liners that predate current gas appliance codes. Corrine Halstead leads our Newark operation, and every job gets a camera scan down the flue before we recommend a dollar of work. If you’re seeing flue tile fragments in your firebox or you’ve been told you need a liner but no one showed you the photos, call us at (862) 245-4309.
What Our Chimney Liner & Rebuild Service Includes
We’ll walk through each type of liner and rebuild work below. Before any of it starts, you get a written scope, a written price, and a written warranty. That’s Clause 1 of the Haven Standard, the operating rules we’ve worked under since 2009.
Stainless Steel Liner
A stainless steel liner is a rigid or flexible metal tube installed inside your existing flue to contain exhaust gases and protect the masonry around it. You need one when your original clay tile liner is cracked, missing sections, or never existed. We install 316L stainless systems from DuraFlex and Copperfield, sized to your appliance and vented with a proper cap and crown seal. The liner comes with a manufacturer’s warranty on the steel, and we document the entire installation with a camera scan before and after so you can see exactly what was in the flue and what’s there now.
Flexible Liner
A flexible liner does the same job as a rigid stainless liner, but it’s built to snake through flues with slight offsets where a straight rigid section won’t fit. You’ll see this on older Newark Chimney Liner & Rebuild homes where the chimney carries a gentle bend between floors, common in the brick rowhouses of the Ironbound and Forest Hill. We pull a measured, single-piece flex liner through the flue and leave you with a photo record of the full run under Haven Standard Clause 4, which has required camera documentation on every job since 2009.
Liner Replacement
Liner replacement means removing the old clay tile or deteriorated metal liner and installing a new system, typically stainless steel. The old liner often has to be broken out in sections, which is dusty work but necessary when tiles have shifted or collapsed. In Newark we regularly pull out liners that date to the 1950s and 1960s, and the clay has spalled so badly that shards are sitting in the smoke chamber. We quote the removal and the new liner as one written price, and the old liner is hauled off the property the same day.
Partial Rebuild
A partial rebuild addresses the section of chimney that’s failing without rebuilding the entire structure. In Newark and nearby, this is usually the top three to five courses of brick above the roofline, where decades of rain and freeze-thaw have turned mortar to sand and left bricks loose. We also handle our Chimney Liner & Rebuild in East Orange. We rebuild from the roof line up, replace the crown and the flue tile extension, and install a proper cap with an animal guard. The work is priced per course of brick and per square foot of masonry repair, so you can see where the dollars go before we lay a single brick. Corrine reviews every rebuild quote personally before it goes out.
Full Chimney Rebuild
A full rebuild means tearing the chimney down to the point where sound structure begins and rebuilding it with new brick, mortar, flue liner, crown, and cap. You’re in full rebuild territory when the masonry is spalling throughout, the chimney has noticeable lean, or the interior flue is so compromised that relining alone won’t fix it. We rebuild to current masonry standards with a code-compliant stainless liner, a poured concrete crown, and a proper cricket behind the chimney where needed. These jobs in Harrison Chimney Liner & Rebuild and Newark typically run three to five days depending on height and access, and you’ll have a photo record of every stage from tear-down to final cap.
Liner Repair
Liner repair covers targeted fixes rather than full replacement: sealing small cracks, repairing a damaged joint, or patching a stainless liner with a matching section. The honest answer is that many “repairs” are temporary, and we’ll tell you when a liner is beyond saving instead of patching it to get another season out of it. When a repair is viable, we do it with materials matched to the existing liner, and the repair area is camera-scanned afterward and added to your photo record. If a competitor has told you the liner is shot, bring us their written estimate and we’ll give you a free second opinion.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service for Chimney Liner & Rebuild
We install and service DuraFlex stainless liners, and we’ve been working with their product line since the company standardized camera-documented inspections in 2009. DuraFlex 316L and 316Ti systems are a mainstay in our Newark work because they hold up to the acidic exhaust from modern high-efficiency gas furnaces, which is a real problem in older flues that were built for wood or oil. We stock their components through Haven’s buying network, which keeps the per-foot price on your quote honest rather than marked up through a retail distributor.
We also work extensively with Copperfield and Famco components. Copperfield makes the rigid and flex stainless systems we use on taller Newark chimneys where a heavier-gauge liner makes sense. Famco’s caps, chase covers, and top plates round out the assembly, and we pair their caps with every liner we install. Whether a home has an existing liner from any manufacturer or no liner at all, we can assess it and bring it to code. The same written price, written scope, and written warranty apply regardless of brand.
BeforeAfterSigns You Need Chimney Liner & Rebuild Right Now
- Flue tile fragments in the firebox or on the roof. Clay tile pieces that break loose and fall means the liner is actively failing. This is one of the most common things our techs find in Newark chimneys, and it means exhaust gases are no longer fully contained.
- White staining or efflorescence on exterior brick. Efflorescence is the salt deposit left behind when water soaks into brick and evaporates. In Newark’s wet winters, repeated freeze-thaw cycles turn that moisture into spalling, and spalling brick loses structural strength over time.
- Rust streaks on the chimney or around the flue. Rust means water is getting past the cap or crown and hitting the liner or damper hardware. A rusted damper is often the first visible sign that the flue above it is compromised.
- Smoke backing up into the room or a persistent draft smell. A cracked liner changes how the flue draws. Smoke and odors that used to vent up the chimney can push back into the living space, especially on windy days or when the furnace kicks on.
- Visible cracks, gaps, or a small lean in the chimney structure. Walk outside and look up. If you can see separated mortar joints, a cracked crown, or a chimney that’s not plumb, the load path is compromised. In a brick rowhouse, a failing chimney is never only your problem – it affects the shared wall and your neighbor’s structure too.
If any of these are present, call (862) 245-4309 and we’ll put a camera down the flue. The inspection shows us what we’re dealing with, and you get the same photos we’re looking at.
Our Chimney Liner & Rebuild Process – Step by Step
- 1
Camera inspection and written assessment. We start with an NFPA 211 Level 2 inspection, which means a camera goes down the flue from top to bottom. You see the footage, we walk through what it shows, and you get a written assessment with the camera stills included. Haven Standard Clause 4 requires this photo record on every visit, and we’ve been doing it since 2009, longer than most Newark chimney companies have existed.
- 2
Written scope and price before any work starts. The quote names the liner type and gauge, the rebuild scope in linear feet or courses of brick, the cap and crown being installed, and the warranty terms. This is a fixed price, not an estimate subject to change once the tech is in your home. Clause 1 of the Haven Standard says it plainly: written price, written scope, written warranty, before anyone starts.
- 3
Tear-down or liner removal, done clean. If we’re rebuilding, we stage tarps, run a debris chute where height allows, and protect landscaping and roofing. If we’re relining, we break out the old clay tiles in sections and haul them off. We clean the flue after removal so the new liner seats properly against clean masonry.
- 4
Installation and proper termination. The new liner goes in and gets terminated with a code-compliant cap and animal guard. If the job includes a rebuild, we lay new brick, pour a new crown with a proper drip edge, and flash the base where the chimney meets the roof. We also install a cricket behind the chimney on wider structures where water ponds, which is a code point that a lot of lower-cost quotes skip.
- 5
Final camera scan and documentation handoff. Before we leave, we send the camera down the finished flue one more time. You get the before and after footage, photos of the cap and crown, a copy of the written warranty, and a completed service record. Everything documented, nothing left to guesswork.
How Much Does Chimney Liner & Rebuild Cost in Newark?
A stainless steel liner installation in Newark typically runs $1,900 to $3,400 for a standard two-story home, including the liner, cap, crown seal, and the final camera documentation. See how much Chimney Liner & Rebuild costs for more detail. A partial rebuild that addresses the top courses of brick above the roofline usually lands between $1,800 and $4,200, depending on how many courses are failing and whether scaffolding is needed. A full chimney rebuild from the roofline up runs $5,500 to $11,000 on most Newark homes, driven by height, access, and brick matching for older structures. Liner repair, when it’s actually viable, runs $600 to $1,400. A camera inspection to see exactly what you’re dealing with is included with your service visit.
What moves the price: chimney height, roof pitch and access, the liner diameter required by your appliance, whether scaffolding is needed, and whether brick needs to be matched to preserve the look of an older home. The difference between a $2,200 liner quote and a $3,900 one often comes down to things like a proper crown rebuild, a cricket, or stainless components rather than aluminum. Those aren’t options; they’re what make the job safe and code-compliant. If someone quotes you a liner for $900, you should ask what cap and crown work they’re including, whether they’re using 316L stainless or aluminum, and whether they’ll provide camera footage afterward. We’d rather show you the difference than compete with a price that shortchanges the top of the chimney.
One more thing: every quote from us includes a documented photo record and a 365-Day Done Right Promise. If something’s not right, we make it right. We also offer a free second opinion on any written estimate, so if you’ve already got a number from another Newark chimney company, bring it in and we’ll go over it line by line with you.
Chimney Liner & Rebuild Near Newark – Our Service Area
We work throughout Newark, from the Ironbound and Forest Hill to Weequahic and Vailsburg, and we serve the surrounding towns too. Harrison’s brick rowhouses share the same freeze-thaw masonry issues Chimney Liner & Rebuild in Harrison and we handle the same liner and crown failures across the Passaic River in Kearny’s older housing stock. We also cover East Orange, Elizabeth, Bayonne, Jersey City, North Arlington, Roselle, Roselle Park, and Linden. Typical scheduling runs three to seven days out for non-emergency rebuild work; if you’ve got flue gases entering the home or a structural concern, call and we’ll prioritize it.
If you’re new to us, a good place to start is our home page, which lays out the Haven Standard and what to expect on your first visit.
Serving Newark, NJ - Our Local Coverage Area
We’re based in the Newark area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Liner & Rebuild in Newark
A chimney liner is the inner sleeve inside your flue that contains exhaust gases and protects the surrounding masonry. Rebuilding is the masonry work that restores the chimney structure itself. The service covers both: assessing the liner condition with a camera, replacing or repairing it as needed, and rebuilding brick and mortar where the chimney has deteriorated. The goal is a flue that safely vents and a structure that won’t fail in Newark’s freeze-thaw cycles.
A standard stainless steel liner install takes one day. A partial rebuild runs one to two days, and a full chimney rebuild takes three to five days depending on height, scaffold requirements, and weather. The initial camera inspection takes about 45 to 60 minutes, and you’ll have a written price before you make any decisions.
You can expect to pay $1,900 to $3,400 for a liner install, $1,800 to $4,200 for a partial rebuild, and $5,500 to $11,000 for a full rebuild. The exact figure depends on flue size, chimney height, access, and whether the crown and cap need replacement. Every quote is written and fixed before work starts. Call (862) 245-4309 for a free estimate.
Yes, we install and service DuraFlex and Copperfield stainless liners and use Famco caps and terminations on most of our Newark jobs. We also work with HeatShield for select clay tile repair applications. If you have a liner from another manufacturer, we can assess it and match components or replace it as needed.
If you suspect flue gases are leaking into the home, that’s urgent and you should call us any time at (862) 245-4309. We answer 24/7 with a live person. For masonry issues that aren’t actively venting into the house, we’ll get you on the schedule within the week and make sure the situation is stable in the meantime.
Every job carries a written warranty on workmanship, plus the manufacturer’s warranty on the liner materials themselves. The warranty terms are written out on your quote before work starts, and they’re backed by the 365-Day Done Right Promise: if it’s not done right, we make it right. No fine print games.
Clear the area around the fireplace a few feet back, move any furniture or decor you want protected, and make sure we have clear access to the roof or the chimney chase. If you’re in a rowhouse, let your neighbors know we’ll be on a ladder. We’ll tarp and clean up thoroughly; you don’t need to do any prep beyond clearing the space. We text when the tech is on the way, and the tech’s name and license number are on your confirmation.
Schedule Your Chimney Liner & Rebuild Service in Newark Today
If your liner is failing or your chimney is showing signs of structural trouble, don’t wait for another winter’s freeze-thaw cycle to make it worse. Call Corrine and our Newark team at (862) 245-4309 and we’ll get a camera down your flue, show you the footage, and give you a written price before any work starts. No pressure, no vague quotes, and a free second opinion if you’ve already got another estimate in hand. We answer 24/7.
Written by Corrine Halstead, Owner at Level Two Chimney Newark, serving Newark since 2009.